Loading paper manually from the sheet guide
The cut-sheet feeder’s single-sheet loading feature allows you to
switch to a different type or size of paper without replacing the
paper already in the cut-sheet feeder or removing the feeder.
Follow these steps:
1. Make sure that the paper release lever is in the single-sheet
position.
2. Set the paper thickness lever to the correct position for your
paper, as described on page 3-6.
3. Close the sheet guide’s extension flap if necessary, and push the
sheet guide extension all the way in.
4. Slide the right edge guide until it is aligned with the guide mark
on the sheet guide.
5. While adjusting the left edge guide to match the width of your
paper, insert a sheet of paper between the edge guides until it
meets resistance. Be sure to load your paper printable side up.
After a few seconds, the printer automatically advances the
paper to the loading position. The printer is ready to accept
data from your computer and print.
After printing a sheet, the printer ejects the printed sheet onto
the sheet guide and the Paper Out and Pause lights come
on. If you are printing a multiple-page document, remove the
printed sheet and insert a new sheet into the sheet guide. The
printer automatically advances the paper and resumes
printing.
LAdonis Rev.E
A5 size Chapter 5
97/04/07 pass 0
5-14 Using Printer Options