Adjusting the tear-off position If your paper perforation is not aligned with the tear-off edge,
you can use the micro-adjust feature to move the perfora tion to
the tear-off position as follows:
1. Make sure both Tear Off/Bin lights are flashing (the paper
is at the current tear-off position). You may need to press
the Tear Off/Bin button.
2. Hold down the Pause button for about three seconds.
The Pause light begins flashing and the printer enters
the micro-adjust mode.
A35-2
3
R
Adonis Rev.E
A5 size Chapter 3
97/04/07 pass 0
Paper Handling 3-31