Using the Default-Setting Mode
The default settings control many printer functions. While you can
often set these functions through your software or printer driver,
you may sometimes need to change a default setting from the
printer’s control panel using the default-setting mode.
For a detailed description of the settings you can change in the
default-settings mode, see the next section. For instructions on
changing the settings, see “Changing the default settings” later
in this chapter.
Default-setting mode options
This section describes the options and settings available in the
default-setting mode. Use the table below for quick reference
when changing default settings. The options are explained in
more detail after the table.
Option Settings
Page length for tractor 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17 inches
Skip-over-perforation On, Off
Auto tear off On, Off
Auto line feed On, Off
Print direction Auto, Bi-d, Uni-d
I/F (interface) mode Auto, Parallel I/F, Option I/F
Auto I/F (interface) wait time 10 seconds, 30 seconds
Software ESC/P 2, IBM 2390 Plus
4
R
Adonis Rev.E
A5 size Chapter 4
97/04/07 pass 0
Using the Control Panel 4-9