Note

If your Macintosh has a built-in modem, connect the interface cable to the printer port.

Using EPSON Drivers and Utilities for Macintosh B-3

3.Connect one end of the interface cable to the serial connector on the back of the printer.

4.Connect the other end of the interface cable to either the modem port or printer port on the Macintosh. (Some Macintosh PowerBook® models have only one serial port.)

5.Turn on the printer by pressing the Power button.

6.Turn on your Macintosh.

See the next section for instructions on installing the printer software. You must install the printer software before using your printer.

Setting Up Your Software

You need to install the drivers and utilities on any Macintosh that will print to the EPSON Stylus Pro 9000 or 9500. Make sure each Macintosh meets the minimum system requirements. Then follow the procedure for installing the software. Depending on your network configuration, you may also want to set up printer sharing if you have the EPSON Stylus Pro 9500.