Monitoring and Configuring the Printer
Error messages (continued)
Message | Light | Explanation | Response |
|
|
|
|
RELOAD PAPER | Paper Out | Paper could not be reversed |
| light on | into the printing position. |
Remove the paper. Reload it so that the right and bottom edges are straight and aligned with both rows of holes.
Image is too wide for the | Resize your image or load wider |
paper loaded in the printer. | paper. |
|
|
Paper is not fully ejected. | Cut the paper at the paper insertion |
| slot, then reload paper. |
|
|
PAPER NOT CUT error was | Reload paper. |
cleared. |
|
REMOVE PAPER | Paper Out | Paper is too thick for head |
| light on | cleaning. |
Push the paper set lever down to remove the paper. Head cleaning automatically starts. After cleaning, reload paper.
SERVICE REQ. | All lights | An error has occurred. | Note the error number, and turn the |
<error number> | flashing |
| printer off and then on. If the |
|
|
| message remains, contact EPSON as |
|
|
| described in the Introduction. |
|
|
|
|
SERVICE REQ. | All lights | The waste ink system is full. | Contact EPSON to have the waste ink |
<00000100> | flashing |
| system replaced. |
|
|
|
|
TURN PWR OFF | — | This message appears after | Turn the printer off and then on again. |
AND ON |
| you clear a paper jam. |
|
|
|
|
|
UNABLE TO PRINT | — | You tried to print a test pattern | After 3 seconds the message |
|
| while an error condition was | disappears. Press the Pause button |
|
| present or the ink | to exit SelecType mode. If the |
|
| compartment cover was open. | message appears again, clear the |
|
|
| error before you print. |
|
|
|
|
WRONG | Ink Out light(s) | Wrong ink cartridge(s) | Install the correct ink cartridge(s). |
CARTRIDGE | on | installed. |
|
|
|
|
|