Error messages (continued)
Message | Light | Explanation | Response |
|
|
|
|
LOAD ROLL PAPER | Paper Out | Paper source setting in print | Make sure the right paper is loaded |
LOAD SHEET | light on | options is different from | and the paper source setting is the |
| control panel. | same on the control panel and print | |
PAPER |
| ||
|
| options. | |
|
|
| |
|
|
|
|
MAINTENANCE | — | A printer part will need to be | Note the error number and contact |
REQ. <error |
| replaced soon. | EPSON as described in the |
number> |
|
| Introduction. |
|
|
|
|
MAINTENANCE | — | The waste ink system is | Call an authorized EPSON servicer to |
REQ 0100 |
| almost full. | schedule replacement of the waste |
|
|
| ink system. |
|
|
|
|
NO INK CARTRIDGE | Ink Out light(s) | Ink cartridge(s) not installed. | Install ink cartridges as indicated by |
| on |
| |
|
|
| instructions. |
|
|
|
|
OPTION I/F ERROR | — | Wrong interface card installed. | Turn off the printer and remove the |
|
|
| |
|
|
|
|
PAPER JAM | Paper Out | Paper has jammed in the | Remove the jammed paper. See |
| light flashing | printer. | |
|
|
|
|
PAPER NOT CUT | Paper Out | Roll paper was not cut | Cut the paper manually, then remove |
| light flashing | completely. | the cut paper from the printer. Reload |
|
|
|
Cut paper did not fall off.
Remove the cut paper from the printer. Reload paper.
PAPER NOT | Paper Out | Paper slipped and fed into the |
STRAIGHT | light flashing | printer at an angle. |
Reload paper, making sure the edges are straight and aligned with both rows of holes.
PAPER OUT | Paper Out | No paper is loaded. | Load paper. |
| light on |
|
|
| Paper ran out. | Remove any printouts or paper | |
|
| ||
|
|
| remaining in the printer and load more |
|
|
| paper. |
|
|
| If the message appears during a print |
|
|
| job, reset the printer by pressing the |
|
|
| Pause button for 3 seconds. Then |
|
|
| load paper and resend the job. |
|
|
|
|
PUSH LEVER | Paper Out | Paper set lever was released | Push the paper set lever down. Start |
DOWN | light on | during the printing process or | printing again from the beginning for |
|
| another operation. | best results. |
|
|
|
|