6.Push the paper set lever all the way down, then close the lower cover. PRESS PAUSE BUTTON appears on the control panel display.
Caution
To avoid damaging the printer, never move the paper set lever while the Operate or Pause light is flashing.
7.Press the Pause button. The print head moves and the board feeds into printing position automatically. READY appears on the control panel. (Even if you don’t press Pause, the board and printer will move into printing position automatically after 10 seconds.)
8.Run your print job. After it is finished, the posterboard stays in the printer.
9.To remove the print, hold it and pull the paper set lever all the way up.
Adjusting the Platen Gap for Heavy Stock
When you print on heavy stock, you may need to adjust the platen gap setting. Normally, the AUTO setting allows the printer to adjust automatically. However, if print quality is not satisfactory when you use heavy stock, change this setting to WIDE. Follow these steps:
1.Press the SelecType button. PRINTER SETTING MENU appears on the display.
2.Press the Item button. PLATEN GAP=AUTO appears on the display.
3.Press the + button. PLATEN GAP=WIDE appears on the display.