A-2Installing an Interface Card

2.Use a Phillips-head (+) screwdriver to remove the two screws securing the shield plate to the back of the printer. Then lift off the plate.

Be sure to keep the screws so you can use them if you re-install the shield plate.

3.Make sure you set any jumpers or DIP switches on the card. See the card’s documentation for details.

On the FireWire card, make sure DIP switch 10 is set to ON (advanced mode).

4.Slide the interface card along the slots on both sides of the compartment. Push it in firmly to fully insert the connector into the printer’s internal socket.