Epson S1C62 Family GO TARGET PROGRAM, #G,R, #G,<address, ■Setting the Starting Address, ■Break Mode and Break Condition

ICE CONTROL SOFTWARE ICS62XX

G

GO TARGET PROGRAM

Format

Function

#G

#G,<address >#G,R

This instruction runs the target program. When a break condition is detected, program execution is halted and the break status is displayed to complete the instruction.

■Setting the Starting Address

(1)When an <address> is entered, the run starts from that address.

(2)With an R setting the evaluation board CPU is reset, and the run starts from the reset address 0100.

(3)When the <address> and R setting are defaulted, the run starts from the current address (PC which displays the status during the previous break).

When G is entered after power on, the run starts from address 0100, but the evaluation board CPU is not reset.

■Break Mode and Break Condition

Item	Break mode (note)	Break condition	Comments
1	Break enable mode	* Reset switch	Mode at power on.
	& break stop mode	* Break switch
		* Break set commands
		(BA, BD, BR, BM)
		* ESC input
2	Break enable mode	* Reset switch	When the break condition and evaluation
	& break trace mode	* Break switch	board CPU executed cycle coincide,
		* ESC input	the bleak status alone is displayed and
			the GO command is restarted.
3	BSYN mode	* Reset switch	When the break condition and evaluation
	& break stop mode	* Break switch	board CPU executed cycle coincide,
		* ESC input	a pulse is output to the SYNC pin.

Note: Refer to Section 2.3.2, "Break mode and break function" for more information on the break mode.

VIII-60	EPSON	S1C62 FAMILY
		DEVELOPMENT TOOL REFERENCE MANUAL