MASK DATA CHECKER MDC62XX

4 ERROR MESSAGES

4.1 Data Error

The program data file and option data file and melody data file are checked during packing; the packed data file is checked during unpacking.

If there are format problems, the following error messages are displayed.4.1.1Program data error

 

Error Message

Explanation

1.

HEX DATA ERROR : NOT COLON.

There is no colon.

2.

HEX DATA ERROR : DATA LENGTH. (NOT 00-20h)

The data length of 1 line is not in the 00–20H range.

3.

HEX DATA ERROR : ADDRESS.

The address is beyond the valid range of the program,

 

 

melody and scale ROM.

4.

HEX DATA ERROR : RECORD TYPE. (NOT 00)

The record type of 1 line is not 00.

5.

HEX DATA ERROR : DATA. (NOT 00-FFh)

The data is not in the range between 00H and 0FFH.

6.

HEX DATA ERROR : TOO MANY DATA IN ONE LINE.

There are too many data in 1 line.

7.

HEX DATA ERROR : CHECK SUM.

The checksum is not correct.

8.

HEX DATA ERROR : END MARK.

The end mark is not : 00000001FF.

9.

HEX DATA ERROR : DUPLICATE.

There is duplicate definition of data in the same address.

 

 

 

4.1.2Function option data error

 

 

 

Error Message

Explanation

1.

OPTION DATA ERROR : START MARK.

The start mark is not "\OPTION". (during unpacking) *

2.

OPTION DATA ERROR : OPTION NUMBER.

The option number is not correct.

3.

OPTION

DATA

ERROR : SELECT NUMBER.

The option selection number is not correct.

4.

OPTION

DATA

ERROR : END MARK.

The end mark is not "\\END" (packing) or "\END" (unpacking).*

* \ sometimes appears as ¥, depending on the personal computer being used.4.1.3Segment option data error

 

Error Message

Explanation

1.

SEGMENT DATA ERROR : START MARK.

The start mark is not "\SEGMENT". (during unpacking) *

2.

SEGMENT DATA ERROR : DATA.

The segment data is not correct.

3.

SEGMENT DATA ERROR : SEGMENT NUMBER.

The SEG No. is not correct.

4.

SEGMENT DATA ERROR : SPEC.

The output specification of the SEG terminal is not correct.

5.

SEGMENT DATA ERROR : END MARK.

The end mark is not "\\END" (packing) or "\END" (unpacking).*

* \ sometimes appears as ¥, depending on the personal computer being used.

4.2 File Error

 

 

Error Message

Explanation

 

 

 

 

 

1.

<File_name>

FILE

IS NOT FOUND.

The file is not found or the file number set in CONFIG.SYS

 

 

 

 

is less than 10.

2.

PACK FILE NAME (File_name) ERROR.

The packed input format for the file name is wrong.

3.

PACKED FILE

NAME

(File_name) ERROR.

The unpacked input format for the file name is wrong.

4.3 System Error

 

Error Message

Explanation

 

 

 

1.

DIRECTORY FULL.

The directory is full.

2.

DISK WRITE ERROR.

Writing on the disk is failed.

IX-4

EPSON

S1C62 FAMILY

 

 

DEVELOPMENT TOOL REFERENCE MANUAL