Extron electronic ISM 482 Command/response table for special function SIS commands

Programmer’s Guide, cont’d
Integration Scaling Matrix Switcher • Programmer’s Guide4-14
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Command/response table for IP SIS commands
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Delay times
RGB delay (Triple-Action Switching)
X
2
*X20*3# Dly
X20
Set switching delay of the
selected input to the selected
output. Adjustable in 0.01
second steps up to 50 = 5.0
seconds. 0 = 0.0 seconds
(default), 1 = 0.1 seconds, 2 = 0.2
seconds, and so on.
Example: 1*35*3# Dly35 Set RGB delay for output 1 set to
3.5 seconds.
Read RGB delay
X
2
*3# X20
Scaler settings
Output sync format
X
2
*
X
7
*6# Syn
X
7
0 = RGBHV (default).
1 = RGBS.
Example: 2*0*6# Syn00 RGBHV signal on output 2.
Read output sync format
X
2
*6#
X
7
Output polarity
X
2
*
X
8
*7# Pol
X
8
X
8
:Horizontal/Vertical polarity
0 = H–/V– 2 = H+/V–
1 = H–/V+ 3 = H+/V+
Example: 1*1*7# Pol01 H–/V+ polarity on output 1.
Read output sync polarity
X
2
*7#
X
8
Set ISM name (location) Esc X30CN Ipn• X30
Read ISM name (location) EscCN X30
Set GMT/date Esc X31CT Ipt•
X32
The date and time entered should be Greenwich Mean Time (GMT).
Read GMT/date EscCT X32
Set IP address Esc •X33 CI Ipi•
X33
The switcher sends the response,
but the host may not receive it.
Read IP address Esc CI X33
Read hardware address EscCH X35
Read # of open connections EscCC X36
Set administrator password Esc •X34 CA Ipa
X34
Read administrator password EscCA X34
Set user password Esc•X34CU Ipu
X34
Read user password EscCU X34
When the computer is connected to the switcher via the RS-232 link, the Admin and User password
fields are not masked. If a password has been inadvertently changed to an unknown value, you can
look up and, if desired, change a password in this window without knowing the current password.
Command/response table for special function SIS commands
The syntax for setting a special function is
X
n
*
X?
# where
X
n
is the value or variable
(such as 35 in the first example below),
X?
is the function number (such as “set RGB
delay” in the first example below), and # is the execute command. To view a
function’s setting, use
X?
# where
X?
is the function number.