Fortinet 119 FortiWeb 5.0 Patch 6 Administration Guide
5. Click OK.
Your new VLAN is initially hidden in the list of network interfaces.
To expand the network interface listing in order to view all of a port’s associated VLANs, click
the blue disclosure arrow next to the name of the port.
See also
•Network interface or bridge?
•Configuring a bridge (V-zone)
•Link aggregation
•Configuring DNS settings
•Adding a gateway
•Fail-to-wire for power loss/reboots
•Global web UI & CLI settings
VLAN ID Type the VLAN ID , such as 100, of packets that belong to this
VLAN subinterface.
• If one physical network port (that is, a VLAN trunk) will handle
multiple VLANs, create multiple VLAN subinterfaces on that
port, one for each VLAN ID that will be received.
• If multiple different physical network ports will handle the same
VLANs, on each of the ports, create VLAN subinterfaces that
have the same VLAN IDs.
The valid range is between 1 and 4094 and must match the VLAN
ID added by the IEEE 802.1q-compliant router or switch
connected to the VLAN subinterface.
For the maximum number of interfaces for your FortiWeb model,
including VLAN subinterfaces, see “Appendix B: Maximum
configuration values” on page 669.
Note: Inter-VLAN routing is not supported if the FortiWeb
appliance is operating in true transparent proxy mode. In that
case, you must configure the same VLAN IDs on each physical
network port.
IP/Netmask Type the IP address/subnet mask associated with the VLAN, if
any. The IP address must be on the same subnet as the network
to which the interface connects. Two network interfaces cannot
have IP addresses on the same subnet.
Setting
name
Description