Fortinet 78 FortiWeb 5.0 Patch 6 Administration Guide
5. Copy the new firmware image file to the root directory of the TFTP server.
6. If necessary, start your TFTP server. (If you do not have one, you can temporarily install and
run one such as tftpd (Windows, Mac OS X, or Linux) on your management computer.)
7. Verify that the TFTP server is currently running, and that the FortiWeb appliance can reach
the TFTP server.
To use the FortiWeb CLI to verify connectivity, enter the following command:
execute ping 192.168.1.168
where 192.168.1.168 is the IP address of the TFTP server.
8. Enter the following command to restart the FortiWeb appliance:
execute reboot
9. As the FortiWeb appliances starts, a series of system startup messages appear.
Press any key to display configuration menu........
10.Immediately press a key to interrupt the system startup.
If you successfully interrupt the startup process, the following messages appears:
[G]: Get firmware image from TFTP server.
[F]: Format boot device.
[B]: Boot with backup firmware and set as default.
[Q]: Quit menu and continue to boot with default firmware.
[H]: Display this list of options.
Enter G,F,B,Q,or H:
Please connect TFTP server to Ethernet port "1".
11.Typ e G to get the firmware image from the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:
12.Type the IP address of the TFTP server and press Enter.
The following message appears:
Enter local address [192.168.1.188]:
13.Type a temporary IP address that can be used by the FortiWeb appliance to connect to the
TFTP server.
The following message appears:
Enter firmware image file name [image.out]:
Because TFTP is not secure, and because it does not support authentication and could
allow anyone to have read and write access, you should only run it on trusted
administrator-only networks, never on computers directly connected to the Internet. If
possible, immediately turn off tftpd off when you are done.
You have only three seconds to press a key. If you do not press a key soon enough, the
FortiWeb appliance reboots and you must log in and repeat the execute reboot
command.