Franklin 2007 manual Power Supply, Transformers, Control Panel, Incoming Voltage, Running Amps

Submersible Motor Installation Record

Power Supply:

Cable: Service Entrance to Control ____________ft_______ AWG/MCM				❑ Copper	❑ Aluminum
				❑ Jacketed	❑ Individual Conductors
Cable: Control to Motor ____________ft________ AWG/MCM				❑ Copper	❑ Aluminum
				❑ Jacketed	❑ Individual Conductors
						P
			PUMP
						U
			PANEL
						M
						P
	SERVICE
	ENTRANCE
						M
Transformers:						O
						T
kVA __________ #1 __________ #2 __________ #3						O
						R
Initial Megs
(motor & lead) T1________T2_______T3________
Final Megs		Control Panel:
(motor, lead & cable) T1______T2______T3______		Panel Manufacturer______________________________
Incoming Voltage:		Short Circuit Device
			❑ Circuit Breaker Rating________Setting_____
No Load L1-L2______ L2-L3_______L1-L3_______			❑ Fuses Rating___________ Type__________
				❑ Standard	❑ Delay
Full Load L1-L2______ L2-L3_______L1-L3_______
Running AMPS:		Starter Manufacturer_____________________________
		Starter Size ___________________________________
HOOKUP 1:		Type of Starter		❑ Full Voltage	❑ Autotransformer
		❑ Other:___________Full Voltage in _____sec
Full Load L1______L2_______L3_______
% Unbalance______		Heater Manufacturer_____________________________
HOOKUP 2:		Number_____________Adjustable Set at _______amps.
Full Load L1______L2_______L3_______		SubMonitor/Subtrol-Plus ❑ No ❑ Yes
% Unbalance______		Registration No. ________
HOOKUP 3:		If yes,
Full Load L1______L2_______L3_______		Overload Set? ❑ No ❑ Yes Set at _______amps.
% Unbalance______		Underload Set? ❑ No ❑ Yes Set at _______amps.
Ground Wire Size ___________________AWG/MCM		Controls are Grounded to:
Motor Surge Protection ❑ Yes ❑ No		❑ Well Head ❑ Motor ❑ Rod ❑ Power Supply

Variable Frequency Drives:

Manufacturer_________________ Model ______________ Output Frequency: _________ Hz Min _________ Hz Max

Cooling Flow at Min. Freq. ___________________________ Cooling Flow at Max. Freq.________________________

Approved Overload: ❑ Built-in ________ ❑ External Model: (per above) ❑ Cables: (per above) Set Amps __________

Start Time ____________sec Stop Mode ❑ Coast __________sec ❑ Ramp __________ sec

❑ Output fi lter ___________ ❑ Reactor _______________% Make __________ Model ___________ ❑ None

Maximum Load AMPS:

Drive Meter Input Amps Line 1 __________ Line 2 __________ Line 3 __________

Drive Meter Output Amps Line 1 __________ Line 2 __________ Line 3 __________

Test Ammeter Output Amps Line 1 __________ Line 2 __________ Line 3 __________

Test Ammeter Make ________________________ Model ________________________