Submersible Motor Booster Installation Record

Insulation Check:

Initial Megs: Motor & Lead Only

Black (T1/U1)_________ Yellow (T2/V1)________ Red (T3/W1)_________

Installed Megs: Motor, Lead, & Cable

Black (T1/U1)_________ Yellow (T2/V1)________ Red (T3/W1)_________

Voltage To Motor:

 

Non-Operating:

B-Y (T1/U1 - T2/V1)_____ Y-R (T2/V1 - T3/W1)_____ R-B (T3/W1 - T1/U1)_____

At Rated Flow of __________gpm

B-Y (T1/U1 - T2/V1)_____ Y-R (T2/V1 - T3/W1)_____ R-B (T3/W1 - T1/U1)_____

At Open Flow ____________gpm

B-Y (T1/U1 - T2/V1)_____ Y-R (T2/V1 - T3/W1)_____ R-B (T3/W1 - T1/U1)_____

Amps To Motor:

 

At Rated Flow of __________gpm

Black (T1/U1)_________ Yellow (T2/V1)________ Red (T3/W1)_________

At Open Flow ____________gpm

Black (T1/U1)_________ Yellow (T2/V1)________ Red (T3/W1)_________

At Shut Off*

Black (T1/U1)_________ Yellow (T2/V1)________ Red (T3/W1)_________

*Do NOT run at Shut Off more than two (2) minutes.

Inlet Pressure __________psi Outlet Pressure __________psi Water Temperature _______ °F or _______ °C

If you have any questions or problems, call the Franklin Electric Toll-Free Hot Line: 1-800-348-2420

Comments: _____________________________________________________________________________________

_______________________________________________________________________________________________

_______________________________________________________________________________________________

_______________________________________________________________________________________________

_______________________________________________________________________________________________

Please sketch the system

Page 38
Image 38
Franklin 2007 manual Insulation Check, Voltage To Motor, Amps To Motor