Fujitsu fi-4340C manual Setting the Scsi ID and the Scsi Terminator, ID No Description

■Connecting the interface cablesBackoftheImagescanner

1.Connect the SCSI interface cables and secure them..

Interfacecables

TothehostTosystemthehostsystem

NOTICE

1.Factory default for the SCSI terminator is On. If the scanner is in the middle of the daisy chain or of two devices, turn the scanner termination Off via the operator panel.

2.The factory default for the SCSI ID is 5. If the ID of the scanner is the same as the other device, change the ID via the operator panel or change the ID of the other device.

■Setting the SCSI ID and the SCSI Terminator

The default of the SCSI ID is 5. The SCSI ID is set by using the Setup mode of the operator panel.

1.Turn the power Off by pressing the “0” side of the power switch.

2.Turn the SCSI-ID switch on the rear of the image scanner to set the SCSI-ID.

ID No.

Description

0 to 7

Can be set

8, 9

Return to default (Available ID NO. = 5) if set to 8 or 9.

3.Set the SCSI terminator switch on the rear of the image scanner to ON or OFF.

●2-4