Fujitsu M3099GH, M3099GX, M3099EX, M3099EH manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

The setup mode can be classified into 17 (M3099EX/EH) or 18 (M3099GX/GH) types.

Mode	Setup type	Contents
1	Setting double feed detection	Set in EEPROM whether double feed detection is done or not.
2	Setting IPC-2 pre-set	Set in EEPROM the pattern No.of IPC-2 pre-set mode.
3	Reset of abrasion counter	Reset the abrasion counter after Belt/Roller are exchanged.
4	Setting buzzer	Set in EEPROM whether the buzzer function is on or off.
5	Setting pre-pick	Set in EEPROM whether pre-picking is done for fast reading or not.
6	Adjusting LCD contrast	Set in EEPROM the LCD contrast.
7	Setting pick speed	Set in EEPROM whether pick speed is fast or slow.
8	Setting initial value of endorser	Set the initial number. The set value can be stored in EEPROM.
9	Setting reset method of endorser reset	Set in EEPROM whether the number is reset by hopper empty detection.
10	Reseting of endorser	Reset the number to the initial value.
11	Reseting of ink counter	Reset the ink counter after the print head is replaced.
12	Setting RS-232C transfer rate *1	Set the transfer rate in EEPROM. (1200/2400/4800/9600).
13	Setting SCSI-ID *2	Set the SCSI-ID. (0-7)
14	Setting Product-ID *2	Set the Product-ID. (M3096G/M3099G/M3099GH)
15	Setting picking start time	Set in EEPROM the time from when the hopper empty sensor is blocked
		in manual mode until picking begins.
16	Setting picking time	Set the time from when picking begins until the SF1 sensor is blocked by
		paper.
17	Setting time-out limit	Set the time from when a command is issued in manual mode until paper
		is actually detected.
18	Setting hopper time	Set the time from when Start Command Time-out limits until hopper table
		is lowered.
19	Setting heater control	Set in EEPROM whether heater control is on or off.
		*1 Available for only M3099EX/EH.
		*2 Available for only M3099GX/GH.

7-2