Setting hopper time
When you set the picking time, you must set as follows:
1 In Screen 2, press 16 times (17 times for M3099GX/GH) to display HOPPER TIMER screen. <Screen 36>
2 Press 
to display Screen 37. (The default setting is 7 seconds.)
3 In Screen 37, press 
until the digit you want to change blinks. Then press 
until the value you want to select appears. (The selectable range is from 0 to 30 seconds in steps of 1 second.)
4 Press Mode 1 and 
at the same time to display Screen 36. The settings are stored in
EEPROM.
5When you close the setup mode, press
Stop .
<Screen 36>
< < S E T U P M O D E > >
H O P P E R T I ME R
<Screen 37>
H O P P E R T I ME R
X X S
(Blinking)
Setting heater control
When you set the heater control, you must set as follows:
1 In Screen 2, press 
17 times (18 times for M3099GX/GH) to go to the HEATER CONTROL screen. <Screen 38>
2 | Press Mode 2 to display Screen 39. | If “ON” | <Screen 38> | ||
|
|
| |||
| is displayed, the heater control will be done. | < < S E T U P M O D E > > | |||
| If “OFF” is displayed, | ||||
| H E A T E R C O N T R O L | ||||
| within 30 seconds, if necessary. When the | ||||
| heater is broken, please set “OFF”. Each |
|
|
| |
| time Mode 1 is pressed, “ON” and “OFF” |
|
|
| |
| appear alternately. The setting is stored in | <Screen 39> | |||
| EEPROM automatically. |
| |||
3 | Press Mode 2 to display Screen 38. When | H E A T E R C O N T R O L | |||
|
|
| |||
| you close the setup mode, press | Stop . |
| O N |
|
|
|
|
|
|
|
