Furuno RC-1500-1T manual Tone Test, 2 Self test results, 3 Tone test, Tone test 1 All characters

4.Press the [Enter] key. The results of the self test are displayed a short time later.

	Self Test
Terminal Unit Test		: ver. 1.xx*1	:OK
Main Unit Test		: ver. 1.xx*1	:OK
Modem Unit Test		: ver. 1.xx*1	:OK
Radio Unit Test		: ID xxxx*2	:OK
DSC Unit Test		: ID xxxx*2	:OK

Printer Unit Test*3: Printer not Ready :NG

*1: Current version no.

*2: Actual ID numbers appears.

*3: OK replaces NG when printer is turned on and

l

Figure 8-2 Self test results

If NG appears for any unit checked, try the self test again. If it appears again, call for service.

Tone Test

1.Select Self Test on the System menu.

2.While pressing and holding down the [Shift] key, press the [ ] key.

Tone Test

1:Tone Test 1 (All Char)

2:Tone Test 2 (Fox)

3:Tone Test 3 (Beta)

4:Tone Test 4 (Mark)

5:Tone Test 5 (Space)

6:Tone Test 6 (BY)

Figure 8-3 Tone test

3.Select test and press the [Enter] key. You may stop a test at anytime by pressing the [Enter] key.

Tone test 1 (All characters)

This test (continuously) checks for proper transmission of all fig- ures, letters and codes. To conduct the test, call a station in the ARQ or FEC modes. Execute the test, confirming that all charac- ters are transmitted correctly. "Now testing Tone Test 1" appears during the testing. Since the test is conducted continuously, you may press [Esc] twice and [F10] key to stop the test and return to the tone test menu.

8-3