Furuno RC-1500-1T manual 2-23, Press Enter to open the destination type window

10. Press [Enter] to open the destination type window.

TELEX

FAX

E-Mail

CSDN

PSDN

X400

DNID

SPEC

TELEX (Prefixed)

FAX (Prefixed)

PSDN (Prefixed)

X400 (Prefixed)

DNID (Prefixed)

SPEC (Prefixed)

Figure 3-41 Selection window for “destination type”

TELEX: Telex communication

FAX: Facsimile service

- to an office facsimile machine

E-Mail:E-mail (electronic mail) Service

CSDN: Circuit Switched Data Network-not used.

PSDN: Packet Switched Data Network

-to an office computer via a data network using X.25 standard.

X400: For future use

DNID: Data Network ID -not used.

SPEC: Ship-to shore requests for safety service, accessed by us- ing special 2-digit codes (See Note 2 below.)

Note 1: When FAX is selected, select “T30 (FAX)” in the “Mo- dem Type” selection display. For further details, refer to page 4-2.

Note 2: When SPEC is selected on the Type line, the Country Code line disappears. Enter two-digit codes on the Sta- tion ID line. Refer to page 4-18 for further details.

11.Set up according to Destination Type selection. The steps which follow show how to set up for TELEX (Prefixed).

12.Press [Enter] to close the destination type window.

13. [

/

] to advance the cursor to the Prefix Code line for prefixed.

14.Press [Enter] to open the prefix code window.

15.Key in prefix code in two digits.

Note that some services may not be available depending on LES.

2-23