Furuno RC-1500-1T manual Registering Scan Channel Groups, 8 Scan entry screen

3.4 Scan Channel Groups

The DP-6 can automatically control radio equipment through chan- nel scanning. The radio equipment scans a number of channels (according to your selection), stopping when your own ID code is detected in an incoming signal. The transmitter is tuned to the cor- responding transmitter frequency, the communication link is es- tablished and the traffic is automatically exchanged. Scanning resumes once the link is disconnected.

You may store a maximum of 10 scan groups, 20 channels per group. Note that scanning is only possible in the ARQ and FEC modes.

Registering Scan Channel Groups

1.Press function key [F5] followed by the [3] key to display the Scan Entry screen.

Scan Entry

Scanning Group List

Create

Change

				Scanning Set Up
	Group Name		:
	Ch Dwell Time		: 4.5 sec (2.7-4.5 sec)
	Mode		: AUTO ARQ FEC
	Auto Search		: OFF ON
	No	Channel	Rx Freq		Tx Freq	Pass/Scan
1						Pass/Scan
2						Pass/Scan
3						Pass/Scan
4						Pass/Scan
5						Pass/Scan
▼ 6

Figure 3-8 Scan entry screen

2.If Create is not underlined, press [ ], [ ] and the [Enter] key to underline it.

3.The cursor is on the Group Name line. Enter suitable group name.

4.Press the [ ] key to advance the cursor to the CH Dwell Time line. Enter channel dwell time in seconds. Dwell time is the time in seconds the receiver waits on each channel in a scan group before it selects the next frequency.

3-7