Furuno RC-1500-1T manual Press Enter to open the selection window, 9 System setup menu, nav port

15. Press [Enter] to open the selection window.

		Setup
			System Setup
	System Date & Time			01:53 97-08-04 (YY-MM-DD)
	Preferred NCS			IOR
	MES Operation Mode
	Nav Port				OFF
	Active Port			DTE1
					EXT
	Message Output Port			DTE1
	EGC Output Port				INT
9. Configuration

Figure 2-9 System setup menu, nav port

16.Select the navigation device which is interfaced to the FELCOM 12.

OFF: No connection

EXT: Select this setting when external navigation device is connected. The FELCOM 12 automatically selects ship’s position information in the order of GPS, LC, and

DECCA.

INT: Internal GPS board provides position data.

Note: The Nav Port setting in the FFA version cannot be set to other “INT.”

Note: If there is no navigation equipment connection (Nav Port setting is “OFF”), you should input dead reckoning posi- tion in the Position menu. Refer to page 2-26.

17.Press [Enter] to close the selection window.

18. Press [

/

] to advance the cursor to the Active Port line.

19. Press [Enter] to open the selection window.

		Setup
			System Setup
	System Date & Time			01:53 97-08-04 (YY-MM-DD)
	Preferred NCS			IOR
	MES Operation Mode			INMARSAT-C
	Nav Port			OFF
	Active Port			DTE1
	Message Output Port			DTE1
				ALL
	EGC Output Port				DTE1
9. Configuration

Figure 2-10 System setup menu, active port

20. Select active port (DTE); “DTE1” or “ALL”.

DTE1: Only DTE1 is active.

ALL: DTE1, DTE2 and PC/DATA are active.

21. Press [Enter] to close the selection window.

22. Press [

/

] to send the cursor to the Message Output Port line.

2-4