Furuno RC-1500-1T manual 3 Scan entry screen, Press the Enter key

6.Press the [ ] key to advance the cursor to Mode. Select the communication mode, AUTO, ARQ or FEC.

7.Press the [ ] key to advance the cursor to Auto Search. Turn Auto Search ON or OFF;

Auto Search ON: Radio stops scanning when it finds the stron- gest (S/N ratio) free-signal frequency. Use it where signal propa- gation in poor.

Auto Search OFF: Scanning starts and stops with the first- received free-signal frequency. Normally, use this position.

8.Press [ ] to place the cursor on the No. 1 line. Enter channel or user channel. See the table on the next page for MARITEX radio channel information. Then, press the [ ] key to select "Scan".

9.Press [ ] to advance the cursor to the No. 2 line. Enter channel number. Repeat this procedure for other channels, up to 20.

10.Press the [Enter] key.

11.Press the [Enter] key again to register scan group.

Scan Entry

	Scanning Group List
MARITEX-A		Create
		Change

				Scanning Set Up
	Group Name		: MARITEX-A
	Ch Dwell Time		: 4.5 sec (2.7-4.5 sec)
	Mode		: AUTO ARQ FEC
	Auto Search		: OFF ON
	No	Channel	Rx Freq		Tx Freq	Pass/Scan
1		1	4268.60		4203.50	Pass/Scan
2		2	6460.00		6302.00	Pass/Scan
3		3	8556.00		8398.50	Pass/Scan
4		4	12818.00		12563.50	Pass/Scan
5		5	17024.00		16790.50	Pass/Scan
▼ 6		6	22607.00		22352.00	Pass/Scan

Figure 7-3 Scan entry screen

To enter another scan group, select Create and then press the [En- ter] key. Repeat steps 3 – 9.

7-4