Gateway 9250C Dhcp Release, Dhcp Renew, Manual Settings, Default IP, Primary DNS, Secondary DNS

Table 2-3Jetdirect sub-menus (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
		DHCP Release	This menu appears if Config Method was set to
			DHCP and a DHCP lease for the print server exists.
			No (default): The current DHCP lease is saved.
			Yes: The current DHCP lease and the leased IP
			address are released.
		DHCP Renew	This menu appears if Config Method was set to
			DHCP and a DHCP lease for the print server exists.
			No (default): The print server does not request to renew
			the DHCP lease.
			Yes: The print server requests to renew the current
			DHCP lease.
		Manual Settings	(Available only if Config Method is set to Manual)
			Configure parameters directly from the device control
			panel:
			IP Address: The unique IP address of the device
			(n.n.n.n), where n is a value from 0 to 255.
			Subnet Mask: The subnet mask for the device
			(m.m.m.m), where m is a value from 0 to 255.
			Syslog Server: The IP address of the syslog server
			used to receive and log syslog messages.
			Default Gateway: The IP address of the gateway or
			router used for communications with other networks.
			Idle Timeout: The time period, in seconds, after which
			an idle TCP print data connection is closed (default is
			270 seconds, 0 disables the timeout).
		Default IP	Specify the IP address to default to when the print
			server is unable to obtain an IP address from the
			network during a forced TCP/IP reconfiguration (for
			example, when manually configured to use BootP or
			DHCP).
			Auto IP: A link-local IP address 169.254.x.x is set.
			Legacy: The address 192.0.0.192 is set, consistent
			with older HP Jetdirect devices.
		Primary DNS	Specify the IP address (n.n.n.n) of a Primary DNS
			Server.
		Secondary DNS	Specify the IP address (n.n.n.n) of a Secondary
			Domain Name System (DNS) Server.
	IPV6 Settings	Enable	Use this item to enable or disable IPv6 operation on the
			print server.
			Off (default): IPv6 is disabled.
			On: IPv6 is enabled.
		Address	Use this item to manually configure an IPv6 address.

22 Chapter 2 Control panel ENWW