Gateway 9250C manual Ping Test, Dest Type, Dest IP, Packet Size, Count, Show Results

Table 2-3Jetdirect sub-menus (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
	Ping Test		This test is used to check network communications.
			This test sends link-level packets to a remote network
			host, then waits for an appropriate response. To run a
			ping test, set the following items:
		Dest Type	Specify whether the target device is an IPv4 or IPv6
			node.
		Dest IP	IPV4: Type the IPv4 address.
			IPV6: Type the IPv6 address.
		Packet Size	Specify the size of each packet, in bytes, to be sent to
			the remote host. The minimum is 64 (default) and the
			maximum is 2048.
		Timeout	Specify the length of time, in seconds, to wait for a
			response from the remote host. The default is 1 and
			the maximum is 100.
		Count	Specify the number of ping test packets to send for this
			test. Select a value from 1 to 100. To configure the test
			to run continuously, select 0.
		Show Results	If the ping test was not set for continuous operation,
			you can choose to display the test results. Select Yes
			to show results. If you select No (default), results are
			not shown.
		Execute	Specify whether to initiate the ping test. Select Yes to
			initiate the test, or No to not run the test.

ENWW Initial Setup menu 25