Gateway 9250C manual Manual Settings Use the Manual Settings menu to, DHCPV6 Policy, Proxy Server

Table 2-3Jetdirect sub-menus (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
			Manual Settings: Use the Manual Settings menu to
			enable and manually configure a TCP/ IPv6 address in
			the format of 123.123.123.123.
		DHCPV6 Policy	Router Specified: The stateful auto-configuration
			method to be used by the print server is determined by
			a router. The router specifies whether the print server
			obtains its address, its configuration information, or
			both from a DHCPv6 server.
			Router Unavailable: If a router is not available, the print
			server should attempt to obtain its stateful
			configuration from a DHCPv6 server.
			Always: Whether or not a router is available, the print
			server always attempts to obtain its stateful
			configuration from a DHCPv6 server.
		Primary DNS	Use this item to specify an IPv6 address for a primary
			DNS server that the print server should use.
		Manual Settings	Use this item to manually set IPv6 addresses on the
			print server.
			Enable: Select this item and choose On to enable
			manual configuration, or Off to disable manual
			configuration.
			Address: Use this item to type a 32-hexadecimal digit
			IPv6 node address that uses the colon hexadecimal
			syntax.
	Proxy Server		Specifies the proxy server to be used by embedded
			applications in the device. A proxy server is typically
			used by network clients for Internet access. It caches
			Web pages, and provides a degree of Internet security,
			for those clients.
			To specify a proxy server, enter its IPv4 address or fully
			qualified domain name. The name can be up to 255
			octets.
			For some networks, you might need to contact your
			internet service provider (ISP) for the proxy server
			address.
	Proxy Port		Type the port number used by the proxy server for
			client support. The port number identifies the port
			reserved for proxy activity on your network, and can be
			a value from 0 to 65535.
Diagnostics	Embedded Test		This menu provides tests to help diagnose network
			hardware or TCP/IP network connection problems.
			Embedded tests help to identify whether a network fault
			is internal or external to the device. Use an embedded
			test to check hardware and communication paths on
			the print server. After you select and enable a test and
			set the execution time, you must select Execute to
			initiate the test.
			Depending on the execution time, a selected test runs
			continuously until either the device is turned off, or an
			error occurs and a diagnostic page appears.

ENWW Initial Setup menu 23