April 2004
3-20
Installing Dampening Material
GE Panametrics strongly recommends applying DMP dampening
material in ALL clamp-on applications to help eliminate signal
noise. The material comes in two versions:
•The DMP-1 self-adh es iv e sheet for applications up to
150°F (66°C). The material comes as two 9 .5-in. (24 cm)
wide sheets cut in sufficient length to cover the pipe
circumference plus an additional tenth of a circumference.
The material can be cut with a utility knife, and comes with
a paper backing that is removed before installation.
•The DMP-3 is a clay-like com po un d for all temperature
applications. If th e temperatu re is over 1 50°F, the PDJ pipe
dampening jacket (available from GE Panametrics with
preapplied DMP-3) must be used with the material.
At a minimum, you should consider applying dampening material
if you have any of the following conditions:
•The distance from the nearest butt weld or pipe flange is
less than 10 ft (3 m);
•The pipe size is under 4 in. (100 mm) diameter and the gas
pressure is 200 psig (14 barg) or lower;
•The pipe is deformed,
•The pipe is old, with a history of scaling or rust,
•The pipe experiences conden satio n on the outside.
Note: Consult a GE Panametrics flowmeter applications
engineer or sales engineer if you have any questions
regarding dampening material.