GE PT878GC Entering Skan/Measure Parameters,

April 2004

4-24 Programming Site Data

Entering Skan/Measure Parameters

IMPORTANT: Do not change the Skan/Measure parameters

unless recommended by GE Panametrics.

If you select one of the Skan/Measure modes in the Measurement

mode window in the Signal Setup option (see page 9-24), the

PT878GC requires you to set up the appropriate parameters. You

can enter this option in either of two ways:

•From the Program Menu, scroll to the Skan/Measure option

and press [ENTER], or

•From the Measurement Mode window (page 8-13), select the

method, press [ENTER], press the [T] key to reach the Skan/

Measure Setup prompt, and press [ENTER] again.

In either case, the screen appears similar to Figure 4-10 below . To

step through each parameter, press the [T] key. Refer to

Figure A-6 on page A-6 of Appendix A, Menu Maps.

Figure 4-10: The Skan/Measure Setup Option

Integrate

Skan/Measure

CancellOK

All

% of Peak

µs

SkanT Offset

M>S Switch

µs

Count Correlate

Limit Meas Delta

Advanced

12.6