Servicing the PT878GC 9-29
April 2004
Setting up Measurement Mode (cont.)
The first prompt asks for the measurement mode detection
method. Use the [W ] and [X] arrow keys to move to the
appropriate radio butt on an d pr ess [ENTER].
You must now enter the setup data covered on page 4-23, if you
have not already done so. Pressing the [T] key takes you to
“Skan/Measure Setup.” Press [ENTER] to open the Skan/Measure
option and enter the parameters discussed on page 4-23.
You have completed entering data for the Measurement Mode.
To leave this window,
•Press the [S] key to return to the Measurement Mode tab,
and the [W] arrow key to move to the Signal Parameter tab
or the [X] arrow key to move to the Pulse/Code tab.
•Press [F2] (Cancel) to return to Operate Mode without
confirming the changes.
•Press [F3] (OK) to confirm the new data and return to
Operate Mode.