Programming Site Data 4-31
April 2004

Entering Skan/Measure Count Parameters (cont.)

3. The next prompt asks for the percentage of Noise Level.
a. Press [ENTER] to enter the text box.
b. Use the numeric keys to enter the recommended value.
c. Press [ENTER] to confirm the entry.
4. If you wish to select (or deselect) Measure Times only
(instead of both Skan and Measure times), press [ENTER] at
the Measure Only prompt.
5. If you wish to select (or deselect) a SNR (signal-to-noise
ratio) test, press the [X] key to highlight th e SNR Test prompt
and press [ENTER].
a. If you have selected SNR Test, the next prompt asks for
the Minimum Noise Level. Press [ENTER], type in the
recommended value, and press [ENTER] to confirm the
entry.
b. The final prompt asks for the Low SNR Error Limit. (The
default is 7.) Press [ENTER], type in the recommended
value, and press [ENTER] to confirm the entry.
Pressing the [T] key returns the meter to the Cycle Number
entry, and pressing the [S] key returns the meter to the Count
tab.
•To confirm the entries and return to Operate mode, press [F3]
(OK).
•To leave the wind ow without conf irming the entries and return
to Operate mode, press [F2] (Cancel) or the [ESC] key.