Gilson 215 manual Exyz, Jccccp, Jcttt

Appendix		C
Exyz	B	Sets X, Y, and Z motor status:

x	-	0 for disable X motor.
y	-	0 for disable Y motor.
z	-	0 for disable or 1 for enable Z motor.

		For example, the following command disables the motors:
		E000.
Fn	B	Relaxes the probes where “n” is the probe selection (a, b, c,
		or d).
H	B	Moves XYZ to home position, homes all four Z-drives, and
		sets the X-pitch to 18 mm.
I	I	Reads status of input contacts and front panel Start and
		Stop buttons. Returns “cccckk” where:
		cccc	-	Status of input contacts A, B, C, and D: 1 if
				closed (shorted), 0 if open.
		kk	-	Status of front panel Start and Stop buttons: 1 if
				button has been pressed, 0 if it hasn’t been
				pressed. Value of kk is cleared after reading.
J	I	Reads status of output contacts. Returns “ccccp” where:

cccc- Status of output contacts 1, 2, 3, and 4: 1 if connected, 0 if disconnected.

p- Status of keypad and auxiliary power: 1 if connected, 0 if disconnected.

Jcccc[p] B Sets output contacts and +24V external power.

cccc- Output contacts 1, 2, 3, and 4: 1 to connect, 0 to disconnect, X for no change.

p- (Optional) Keypad and auxiliary power: 1 to connect, 0 to disconnect, X for no change.

jcttt B Pulses an output contact:

c - Number of the output contact, 1–4.

t- Duration of the pulse in tenths of seconds; default is 1 which is 100 ms.

GSIOC Commands

C-5