2
Z-Arm Installation
Follow these steps to install the Z-arm:
1Using a Phillips screwdriver, loosen the mounting screw on the Z-arm mounting bracket located on the Y-arm. Turn counterclockwise to loosen.
2Partially pull out the bracket. Do not remove completely.
3Place the Z-arm into the mounting bracket. You will need to insert one side of the Z-arm into place at a time.
4Tighten the screw on the mounting bracket until the Z-arm is secure.
You’ll adjust the Z-arm to its proper height after rack and rinse station installation. This adjustment is described on page 2-14.
