Installation

Installing the Z-Arm Cable Support Rod

1Using the two Phillips screws, attach the cable support rod bracket in the holes located in the rear of the X-arm extrusion.

2Extend the arm to the extreme X- and Y-direction to ensure that the cable will have enough slack. Plug the Z-arm control cable into the back topside of the control cabinet. The control cable should be tucked into the groove located in the top of the X-arm extrusion. The retaining clip that is already on the control cable should be snapped onto the top of the cable support rod. Refer to diagram below.

2

Z-Arm Installation

2-5

Page 21
Image 21
Gilson 215 manual Installation Installing the Z-Arm Cable Support Rod