Portable Dryer Troubleshooting | Competitor Wiring Reference |
Programming Instructions Using Palm Pilot
On the Competitor Dryer there is only one board to program. This board is called the CPU Display board. It is mounted to the door of the lower box. To access, open the door and the pro- gramming jack is located on the back of this board. To program, follow the instructions below.
1.Turn the control power on the dryer to the off position.
2.Locate the programming jack (J2 connector) on back of board.
3.Unplug the communications cable that is connected to that connector. This is the cable that runs from the CPU/Display board and IO Board.
4.Connect the
5.On the Palm Pilot select the program for that particular board and tap on it.
6.Turn the dryer control power back on.
7.The programming process should begin, it will erase the present program and start the new program.
8.A screen will come up telling you when the transfer of software is complete.
9.When the process is complete turn dryer control power off, remove the connector from the board and plug the communications cable back on to the CPU/Display board.
10. Turn on the dryer and the opening screens should indicate the latest version of software.
Refer to next page for more information on programming the Series 2000 board.
If ordering Palm Pilot from GSI there are two kits available:
D03-0692 ( Palm Flash Program Kit Deluxe )
D03-0693 ( Palm Flash Program Kit Economy )
93
