
111
User switched from continuous flow to batch while dryer is running.
Grain temperature sensor open. One or both leads are off (open circuit)
(SEE FIGURE 4)
Grain temperature sensor leads are shorted together OR sensor is shorted.
(See Figure 4)
Plenum temperature sensor is open. One or both leads are off (open circuit)
(See figure 4)
Plenum temperature senosr leads are shorted together OR sensor is shorted.
(See figure 4)
Flame probe shorted to AC ground.
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
Illegal flame sense. Error 7 is most likely caused by stuck open solenoid. Error 7 will not shut down fan until loss of flame is detected by control. Error 7 may also be caused by a bad ballast resistor (ballast resistor not open between poles). It may also occur if 1 of the 12 volt DC limits is shorted to AC ground, or either temperature senosr is shorted to AC ground.
No safety circuit voltage.
I/O board communication failure I/O board and master have lost communication.
User supplied safety.
Mercoid gas pressure safety.
This indicates that one of the other on screen errors (vapor, plenum, housing temp