Hach 900 MAX 5 Conductivity Probe, Conductivity Probe Connection, Conductivity Probe Wiring J20

Section 5

5.5 Conductivity Probe

5.5.1 Conductivity Probe Connection

Table 11 Conductivity Probe Wiring (J20)

Pin	Signal Description	Wire Color
A	Probe	Black
B	Probe	Red
C	RTD	White
D	RTD	Green

5.5.2Conductivity Probe Programming

1.From the Main Menu, select OPTIONS>ADVANCED OPTIONS>DATALOG.

2.Highlight Select Inputs using the UP and DOWN keys. Press SELECT.

3.Highlight Conductivity (COND.) using the UP and DOWN. Press SELECT.

4.Press CHANGE CHOICE to cycle between Logged and Not Logged, then press ACCEPT.

5.Enter a logging interval using the numeric keypad, then press ACCEPT. Valid logging intervals are shown on the status bar along the bottom edge of the display.

6.Press CHANGE CHOICE to select the appropriate units (ms, µs). Press ACCEPT to continue.

7.Select another channel to configure or press RETURN to back up one step. Press MAIN MENU to return to the Main Menu display.

5.5.3Conductivity Temperature Programming

1.From the Main Menu, select OPTIONS>ADVANCED OPTIONS>DATALOG.

2.Highlight Select Inputs using the UP and DOWN keys and press SELECT.

3.Highlight Conductivity Temperature (COND. TEMP.) using the UP and DOWN keys, then press SELECT.

4.Press CHANGE CHOICE to cycle between Logged and Not Logged, then press ACCEPT.

5.Enter a logging interval using the numeric keypad, then press ACCEPT. Valid logging intervals are shown on the status bar along the bottom edge of the display.

6.Press CHANGE CHOICE to select temperature units (°C, °F). Press ACCEPT.

Page 76
Conductivity Probe	8990options.fm