Hand Held Products 5700 manual Connecting the Scanner, Cable, Keyboard, and Terminal will vary

Connecting the Scanner

Install the scanner by following the steps shown below:

➊Turn off the power to the host system.

➋Connect the interface cable to the scanner and to the terminal/computer.

3

Disconnect

2

1 Keyboard Wedge Interface Example

(Cable, Keyboard, and Terminal will vary.)

➌Turn on the power to the host system.

➍Program your scanner to work with your terminal or computer by scanning the Terminal Set–Up Codes. Either scan the Plug and Play codes (Pages 1–7 to 1–10) or use the Supported Terminal list (Pages 1–11 to 1–12) to determine your terminal’s Terminal ID.

With Plug and Play programming, you connect the scanner and scan only one bar code to program the scanner to work with a designated interface, including any required prefixes and suffixes.

➎To determine if your scanner is set up correctly, scan one of the sample bar codes on the back cover of this guide.

SCANTEAM 5700 User’s Guide 1–3