Heat & Glo LifeStyle XLR-PB-AU, XLR-N-AU manual Constructing the Appliance Chase, Clearances

B. Constructing the Appliance Chase

A chase is a vertical box-like structure built to enclose the gas appliance and/or its vent system. In cooler climates the vent should enclosed inside the chase.

NOTICE: Treatment of ceiling firestops and wall shield firestops and construction of the chase may vary with the type of building. These instructions are not substitutes for the requirements of local building codes. Therefore, you MUST check local building codes to determine the requirements to these steps.

Chases should be constructed in the manner of all out- side walls of the home to prevent cold air drafting prob- lems. The chase should not break the outside building envelope in any manner.

C. Clearances

NOTICE: Install appliance on hard metal or wood surfaces extending full width and depth. DO NOT install directly on carpeting, vinyl, tile or any combustible material other than wood.

WARNING! Risk of Fire! Maintain specified air space clearances to appliance and vent pipe:

•Insulation and other materials must be secured to prevent accidental contact.

•The chase must be properly blocked to prevent blown insulation or other combustibles from entering and making contact with fireplace or chimney.

•Failure to maintain airspace may cause overheating and a fire.

Note: Figure 5.2 shows the fireplace installed on the floor. However, this fireplace can be elevated off the floor provided that the fireplace is properly supported by framing materials and the ceiling clearances are maintained.

NOTE: Frame opening height is greater than plaster opening height.

A

F

B

C

D

MEASURE FROM TOP

OF FIREPLACE OPENING

E

H J

G

I

MINIMUM FRAMING DIMENSIONS*

	A	B	C	D	E	F	G	H	I	J
	Rough	Rough	Rough	Rough	Clearance	Combustible	Combustible	Behind	Sides of	Front of
	Opening	Opening	Opening	Opening
					to Ceiling	Floor	Flooring	Appliance	Appliance	Appliance
	(Vent Pipe)	(Height)	(Depth)	(Width)
Inches	8-3/4	42	18	50	31	0	0	1	1	36
Millimeters	220	1070	460	1270	790	0	0	30	30	910

Figure 5.2. Clearances to Combustibles

20 Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. M • 5/12