J. Lighting Instructions (IPI)
The IPI system may be operated with two
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
LIGHTING 
INSTRUCTIONS (IPI)
1. This appliance is equipped with an ignition |
device which automatically lights the burner. |
DO NOT try to light the burner by hand. |
A. This appliance is equipped with an intermittent pilot ignition (IPI) device which automatically lights the burn- er. DO NOT try to light the burner by hand.
B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•DO NOT try to light any appliance.
•DO NOT touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas sup- plier, call the fire department.
C. DO NOT use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
GAS
VALVE
2. | Wait five (5) minutes to clear out any gas. |
| Then smell for gas, including near the floor. If |
| you smell gas, STOP! Follow “B” in the Safety |
| Information located on the left side of this la- |
| bel. If you do not smell gas, go to next step. |
3. | To light the burner: |
| Equipped with wall switch: Turn ON/OFF switch |
| to ON. |
|
|
| |
WARNING: |
| CAUTION: | |
DO NOT CONNECT LINE VOLT- | Hot while in operation. DO NOT touch. | ||
AGE (110/120 VAC OR 220/240 | Keep children, clothing, furniture, gaso- | ||
VAC) TO THE CONTROL VALVE. | line and other liquids having flammable | ||
Improper installation, adjustment, al- | vapors away. | ||
DO NOT operate the appliance with | |||
teration, service or maintenance can | |||
cause injury or property damage. Re- | fixed glass assembly removed, cracked | ||
or broken. Replacement of the fixed | |||
fer to the owner’s information manual | |||
glass assembly should be done by a | |||
provided with this appliance. | |||
licensed or qualified service person. | |||
This appliance needs fresh air for | |||
| |||
safe operation and must be installed | NOT FOR USE | ||
so there are provisions for adequate | WITH SOLID FUEL | ||
combustion and ventilation air. | |||
If not installed, operated, and main- | For use with natural gas and propane. | ||
tained in accordance with the manufac- | A conversion kit, as supplied by the | ||
turer’s instructions, this product could | manufacturer, shall be used to convert | ||
expose you to substances in fuel or | this appliance to the alternate fuel. | ||
fuel combustion which are known to the | Also Certified for Installation in a | ||
State of California to cause cancer, birth | |||
Bedroom or a Bedsitting Room. | |||
defects, or other reproductive harm. | |||
For assistance or additional informa- | |||
Keep burner and control compartment | |||
tion, consult a qualified installer, ser- | |||
clean. See installation and operating | |||
vice agency or the gas supplier. | |||
instructions accompanying appliance. | |||
| |||
For additional information on operating your
Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.
Equipped with remote or wall control: Press |
ON or FLAME button. |
Equipped with thermostat: Set temperature to |
desired setting. |
4. If the appliance does not light after three tries, |
call your service technician or gas supplier. |
TO TURN OFF 
GAS TO APPLIANCE
1.Equipped with wall switch: Turn ON/OFF switch to OFF.
Equipped with remote or wall control: Press OFF button.
Equipped with thermostat: Set temperature to lowest setting.
2.Service technician should turn off electric power to the control when performing service.
Final inspection by
Heat & Glo • | 13 |
