Hitachi DZ-BD10HA Storing discs, Disc Cleaning, Momentary stop of playback image

*

Block noise

All Scenes

10/ 1/2008 10:10:10 AM

PLAY SEL SELECT EXIT

Fig. 1

Additional Information

•Use a disc which is not dirty, scratched, or warped. (BD/DVD)

•A Hitachi Maxell disc is recommended. (BD/DVD)

•Do not use the camcorder in a place where the humidity is high or the temperature is very low.

•If there is concern that the camcorder may be subjected to large vibrations or impact during transport, remove the BD/DVD/Card and protect the camcorder using soft protective materials.

•When the camcorder is subjected to an impact while a BD/DVD disc is loaded, a mark may form on the disc surface due to the impact protection function for the disc and pickup. This mark can be wiped off using a dry soft cloth.

•Be careful when removing the disc since the metal of removal slot of camcorder, and disc itself, may be hot.

•For card handling, see p.22.

Storing discs

•If the camcorder is not used for long periods of time, remove the disc from the camcorder.

•When storing disc, replace it in the plastic case in which it was purchased.

•Be careful that no condensation occurs on disc.

•Do not place disc in following places:

−Direct sunlight for a long time

−Where humidity is high or in dusty place

−Where there is heat from a heater, etc.

If the above countermeasures are not taken, the following symptoms may occur: − Block noise in playback image,

momentary stop of playback image

0010/0027

− Sound interrupted during playback, or abnormal sound

− Blue thumbnail display* (Fig. 1)

− Disc cannot correctly be recognized − Disc cannot be initialized

−Recording/Playback is not possible

zDisc Cleaning

•Use a dry soft cloth to lightly wipe off any dirt adhering to the disc as shown in the figure. Do not wipe the disc with force: Doing so could cause scratches.

Never use solvent (thinner, water, antistat or detergent) for cleaning.

108