Hitachi DZ-BD10HA instruction manual 104

Additional Information

Symptom		Cause and Correction	Reference
			page
Disc cover cannot be	Is the disc correctly inserted?		23
closed.	Remove the disc and then reinsert it.
	Connect a fully charged battery or AC adapter/charger,		18, 25
	and then turn the camcorder on and try again.
Operating noise is	This is not a fault. A quiet operating sound is heard as the		—
heard.	disc rotates during recording or playback, etc.
Some vibrations are	These vibrations or sound are caused by HDD/disc drive.
felt or slight sound is	This does not indicate a fault.		—
heard from
mechanism.
• No operation can	In the following cases, it will take more time than usual
be performed	until operation is possible:
because the	• Immediately after a disc is inserted.
ACCESS indicator	• When a long time has elapsed since the camcorder was
on this camcorder	turned off last.
remains lit or	• When the temperature is greatly different from the		—
flashing.	status of previous recording.
• After a disc or	• When a scratched or dirty disc is inserted.
card is inserted, it	• When the camcorder is subjected to strong vibrations.
takes some time	• When the battery or DC power cord was disconnected
until recording is	before turning the power switch off.
possible.
No image appears on	• Is the camcorder connected to a PC with a USB cable?
the LCD screen.	Disconnect the USB cable.
	• In playback mode, did the last scene viewed end in a		68, 81
	wipe to black edit?
	Press	.

104