Hitachi DZ-BD10HA instruction manual Default Full Auto, Using the Flash, Flash mode

Select “Camera Functions

2Setup” “MIC. Filter” “On”/“Off”

Press the confirmation button to confirm, then MENU to end.

When the function is turned On,

“ ” appears in the LCD monitor (p.31).

• The MIC. filter setting is

3retained in memory even when the power is turned off.

•If you set this function to “On”, it is recommended to set the function to “Off” after recording before turning off the power unless you always intend to use this function.

	HDD	BD-RE BD-R RAM	-RW (VR) -RW (VF)	R CARD
	Restoring all the
	Recording Settings to
Various	Default (Full Auto)
	You can reset the following manually
Recording	adjusted recording settings to their
		Function	Default	See
	defaults with the press of a single
	button.
Techniques
	Focus		Auto	p.45
	(recording mode)		Auto	p.47
	Exposure		Auto	p.46
	BLC (Backlight)		Off	p.47
	Program AE
	White Balance		Auto	p.48
	OIS (Optical		On	p.50
	Image Stabilizer)
	MIC. Filter		Off	p.51
	Face Detection		On	p.50

Setting the recording settings to full auto

During recording pause or recording, press FULL AUTO.

1“FULL AUTO” appears in the LCD monitor for a while and the settings are reset to their default settings.

CARD

Using the Flash

As shutter speed will slow down when still photos are recorded in dim lighting, camera shake may easily occur. We recommend you use a flash in this case.

Normally, the flash fires automatically depending on the recording conditions (during Auto). You can also set the flash to On (always fires) or Off (does not fire).

Flash mode

Auto

The flash fires only when necessary. When the flash is needed, “ ” appears in the LCD monitor when you press PHOTO halfway, and then the flash fires when you press PHOTO all the way.

On

“” is displayed in the LCD monitor all the time. The flash fires when you fully press PHOTO.

Off

“ ” is displayed in the LCD monitor and the flash will not fire.

52