Hitachi DZ-BD10HA Using the Optical, Turning OIS Off/On, Using the Face Detection

Notes

•It may be difficult to perform this setting in dark places. Also if the zoom bar is positioned in the digital range (p.32), you may not be able to set the white balance. If white balance settings cannot be accomplished,

“” will continue to flash.

•If the “Set” settings are not completed within a few moments, the camcorder returns to recording pause mode and “” flashes in the LCD monitor.

Redo the settings from step 1.

	HDD	BD-RE BD-R		RAM -RW (VR) -RW (VF) R CARD
	Using the Optical
	Image Stabilizer (OIS)
	OIS corrects camera movement
	automatically.
	Turning OIS Off/On
Various		During recording pause, press
	1
		MENU.
		Select “Camera Functions
Recording	2
		Setup”		“OIS” “On”/“Off”
		Press the confirmation button
		to confirm, then MENU to end.
Techniques		When the function is turned On,
		“	” appears in the LCD
		monitor (p.31).
	3	• OIS is retained in memory
			even when the power is turned
			off.

•If “Off” is selected, be sure to return the setting to “On” afterwards, if you do not normally use a tripod, etc.

Notes

•When OIS is active, there will be a slight divergence between the actual camera and the on-screen movements.

•Even if OIS is turned On, the camera movement may not be corrected if the movement is too excessive.

We recommend you stabilize the camcorder using both hands and support your arms against your body when recording.

•OIS may not function correctly when a tele-conversion lens or wide- conversion lens is used.

•We recommend turning OIS Off when you position the camcorder on a table or use a tripod when recording.

HDD BD-RE BD-R CARD

Using the Face Detection

Face Detection automatically recognizes up to five faces and shows them in green frames.

Turning Face Detection On/Off

Press .

When the function is turned On,

“” appears in the LCD monitor (p.31).

• Face Detection is retained in memory even when the power is turned off.

• Recording with digital zoom disables Face Detection even if

1it is set to “On”. When recording with digital zoom (p.44), “” appears in the LCD monitor.

When you return the zoom to the optical range, “ ” appears in the LCD monitor and Face Detection becomes active. (You can set Face Detection to “ON”/ “OFF” while the zoom bar is positioned in the digital range.)

50