Hitachi DZ-BD10HA instruction manual 25, 56

Message	Cause & Troubleshooting	Reference
		page
There was no scene	This message will appear if you try to delete multiple
which can be	scenes when all the selected scenes have been locked.	66, 69
deleted.	Release the lock on scenes before deleting.
This disc cannot be	A disc that cannot be used on this camcorder has been
used. Please replace	loaded. Check the type of disc.	21
disc.
This disc is recorded	This camcorder can use only discs recorded in the NTSC
by the PAL system.	system. A disc recorded in the PAL system cannot be	—
Please replace disc.	used.
Unformat HDD/	• The HDD/Disc/Card may not be formatted or it may be
Disc/SD Card.	damaged. Use another disc.	—
	• See *2 on p. 95.
Use AC adapter/	No dubbing, HDD deletion, or disc finalization is	25, 56, 77,
charger.	possible with a battery pack.	109
Use AC adapter/	Scenes cannot be repaired when the camcorder is
charger.	powered by a battery pack.
Turn off power.	If the AC adapter/charger is unavailable in handy place,	25
	remove the disc and use another disc. Repair the disc
	later.
Video data being	The battery pack or AC adapter/charger may have been
analyzed…	detached while the power is turned on. Be sure to turn the	—
	power off before detaching the battery pack or AC
	adapter/charger.
Write protected.	A card with the erase prevention switch locked is	22
Check SD Card.	inserted. Unlock the switch.
Write protected.	The disc is write-protected. Use the disc navigation menu	72
Check Disc.	to release the protection.

*1

•This message may also appear if the disc is dirty. If this message appears when a recorded disc is recognized immediately after it is inserted, do not repair the disc; remove it and then use a dry soft cloth to clean off the dirt before using it.

•This message may also appear when condensation occurs. In this case, do not repair the disc; turn the camcorder off, wait until it dries out, and then turn it on again.

•If the repair message appears when you turn the camcorder on from off with a disc loaded after recording on it, choose repair.

•If the repair message appears when recording and playback are normally possible with another disc

–and no condensation has occurred, and the disc is not dirty – choose repair.

*2

•This message may also appear if the disc is dirty. In this case, do not format the disc. Remove it and then use a dry soft cloth to clean off the dirt before using it.

•This message may also appear when condensation occurs. In this case, do not format the disc; turn the camcorder off, wait until it dries out, and then turn it on again.

•Formatting will delete all data on the disc.

Additional Information

95