Hitachi DZ-BD10HA instruction manual System Reset, Menu

Note when transferring this camcorder or discarding discs and cards

•The “Format” function on this camcorder will only change the file control information. It will not completely delete the data in the built-in hard disk and your personal data could leak out. To prevent the data from leaking out, execute complete deletion of the HDD following the procedures below.

1While the camcorder is in HDD recording pause mode, press , then press

MENU.

2Press f/e to select “HDD Setting”, then press c.

3Press f/e to select “Full Format”, then press the confirmation button.

4Press d to select “YES”, and then press the confirmation button to confirm the setting and begin HDD full format.

•When transferring or discarding a disc, it is recommended that you physically destroy it or use deletion exclusive software (generally available) to completely delete the data on it. It is user’s responsibility to control the data on disc and memory card.

•Hitachi will not accept any responsibility for leaking of personal data.

System Reset

If the camcorder does not operate normally, perform “System Reset”. The camcorder may recover to normal. “System Reset” will reset all settings to the factory defaults. The date and time will also be reset. Set the date and time again before using the camcorder.

1Set the power switch to “OFF” to turn the camcorder off. Detach the battery or AC adapter/charger.

2Use a fine tipped pen to hold down RESET for

several seconds.

All settings will be reset.

Note

Do not press RESET with undue force.

Additional Information

109