Hitachi DZ-BD10HA instruction manual Camcorder to make repairs

Symptom	Cause and Correction	Reference
		page
The subjects are	An out-of-frame light source (sun, window, lights, etc.) is
recorded too dark.	strong, and the subjects are lit from the rear. Use the	47
	Backlight Compensation function and be creative with
	angles.
The brightness of the	The brightness of the subjects as the light source changes	—
subjects changes.	and camcorder automatically adjusts exposure.
The edges of bright	This is not a malfunction. The subjects may be too high
and dark subjects are	in contrast. Be creative to find a good angle and reduce	—
blurred and	the contrast among subjects.
discolored.
The moving subject	The image will be less burred when there is a better light
looks blurred in	source during recording.	—
pause during
playback.
The sound volume	This is not a malfunction. The camcorder automatically
changes during	adjusts the volume level for recording sound. Recording	—
recording.	volume level cannot be adjusted manually.
The LCD screen	Did you press the LCD monitor or the area around it?
appears unevenly.	If the LCD monitor is pressed, some distortion will occur.	—
	Release your hand and leave the LCD monitor for a
	while. The LCD screen will recover.
Focus is not correct.	Is it difficult to use auto focus with your subject?	45
	Focus manually.
	Does the manual focus icon appear?
	The camcorder is set to manual focus. Focus the subject	45
	manually, or release manual focus.
	If the above causes do not apply, turn off the power and	—	Additional
	camcorder to make repairs.
	turn it on again.
An error message for	Follow the on-screen instructions to repair.
repair appears.	You must connect the AC adapter/charger to the
	Depending on the situation, it could take from a few	25	Information
	minutes to several hours for repair. If you wish to start
	recording immediately, replace the disc, and do the repair
	later. The removed disc can be repaired after you connect
	the AC adapter/charger to the camcorder.

99