Holder 4.74 manual 152

Operating instructions

General remarks on maintenance

C 4.74

•Do not run engine in enclosed spaces! Danger of poisoning!

•To prevent the danger of fire, keep the vehicle and implements clean!

•When leaving the vehicle, secure it against rolling and unauthorized use (parking brake, chocks), stop the engine, remove the ignition key and, if required, lock the cabin!

•Never leave the vehicle unattended while the engine is running!

•If external power loads are connected, eg equipment with solenoid valves, protect them with diodes against back currents. If not, the traction electronics could be affected.

•Operate the equipment only if all guards are installed and in position.

•Install and remove the articulated shaft only with the engine stationary.

•When working with the PTO shaft, no-one should be standing in the area of the rotating PTO and articulated shaft.

•The guards for the articulated shaft and the PTO shaft must be installed as specified.

•When the articulated shaft is removed, refit the protec- tive cap on the PTO shaft.

•Do not perform any welding, cutting and grinding work on carrying and other safety-relevant parts such as vehicle frame, axles, trailer hitch, etc.

•When doing electric welding, disconnect all connector plugs from the electronic units.

•The mounting of tires requires sufficient knowledge and special mounting tools.

•Only use genuine HOLDER replacement parts! Use the parts in the list of maintenance parts in the chapter entitled “Maintenance data“.

•The vehicle and the implement must be checked for road worthiness and operating safety before taking it into operation and after servicing or repairs.

152 149 443