Holder 4.74 manual Installing the cardan shafts, Removing implements

C 4.74

Operating instructions

Operating the implements

Installing the cardan shafts

Only use shafts suitable and intended for the implement. These shafts are supplied with the implement. The length the of the shaft must be adjusted before the first installa- tion. In case of doubt, please contact our after-sales serv- ice. Observe installation instructions for the cardan shaft when installing it.

DANGER

Shut off the engine before the installation. Fit the protective devices as specified after the installation.

Removing implements

-Drive the implement to its storage place and lower it with the front power lift.

-Stop the engine, but do not turn the ignition off.

-Operate all control levers for the front power lift several times in all directions. This will relieve the pressure in the hydraulic system.

-Slide the outer ring of the hydraulic couplings (1) back and disconnect the hydraulic hoses (2).

-Close the protective caps on the hydraulic couplings (as with item 4).

-Remove the upper link from the pin of the upper link support.

-Pull the catches (3) up to release the implement pins.

-Lower the front power lift and drive forward carefully.

Bild_C234

4 1 2

3 Bild_C267

149 443 85