Holder 4.74 manual Adjusting the pintle hooks and pintle hook bars

Operating instructions

Operating the implements

C 4.74

Adjusting the pintle hooks and pintle hook bars

You can adjust the pintle hooks laterally and longitudinally.

-Measure the stand-off of the pins on your implement.

-Loosen the clamping screws (6) on both sides.

-Slide the pintle hooks laterally until the required distance is reached.

-Retighten the clamping screws.

-Equipment of category IIcan be attached with the pintle hooks (5) directly.

-For equipment of category I install the reducing sleeves on the left and right side.

Adjusting the length of the pintle hook bar

-Loosen the 2 locknuts and clamping screws (inside and at bottom) on the lower link (2).

-Pull the retaining clip out of the pin (1) and remove the pin.

-You can put the pintle hook bar (3) in one of 3 posi- tions.

-Insert the pin (1) in the hole and secure with the retaining clip.

-Retighten the locknuts and clamping screws.

DANGER

Make sure no-one is standing between the vehicle and implement.

-Drive the vehicle to the implement to be attached.

2 3 4

1

		6				5	Bild_C233
1	Pin with retaining clip			4		Catch
2	Lower link support			5		Pintle hook
3	Pintle hook bar			6		Clamping screw
	(adjustable) with 3 positions
Hole			Position		Used for
1st hole			Front		Category I and II
2nd hole			Centre		Category I
3rd hole			Rear		Optional attachments

-Steer the pintle hooks (5) under the attaching pin of the implement.

-Raise the front power lift until the catch (4) closes and engages.

82 149 443