Honeywell 800-08091V3 manual Automation contd, Enroll a Door Lock, Icon, Action

Automation (cont'd)

Enroll a Door Lock

Assemble the Z-Wave door lock. NOTE: Be sure the door lock orientation/handedness is correct. Refer to the Door Lock’s Instruction Guide and connect necessary cables, then install batteries. Enroll the door lock within 5 ft of the keypad; refer to the Door Lock’s Instruction Guide for enrollment procedure.

NOTE: Program the user code in the control panel prior to programming that user code into the door lock. User Codes must be 4- digits.

Enroll a door lock device as follows:

ICON	ACTION	NOTES
	1. At the Tuxedo Touch keypad:	Note: Door lock devices may vary; follow the instructions in the Users Guide
	a) Press the Automation icon From the	for your specific door lock to enroll properly and to program a new user code.
	“Home” screen and then press the Z-Wave	The keypad displays a series of messages:
		“Please press *function key on device”
	Setup icon to display the “Z-Wave Device
		“Adding to Security Network”
	Management” screen.	“Device added successfully”

b)Press the Z-Wave Enroll/Add icon. * Enrollment procedure may vary depending on the door lock device. Refer to

2. At the Door Lock:	the door lock instructions for enrollment procedure.
a) Program the selected user code from the	Note: If software is upgraded on the Tuxedo Touch keypad, enroll the door
panel; refer to Door Lock User Guide.	lock again and re-set the user code in the door lock.

Enroll a Honeywell Thermostat

Install Honeywell Thermostat according to the manufactures instructions. Device should be mounted in the final location and tested before adding it to the system.

Note: Honeywell is not responsible for property damages due to improper setting of the thermostat modes. To enroll a Honeywell Thermostat into a Z-Wave network, do the following:

ICON		ACTION	NOTES
	1. At the Tuxedo Touch Keypad:		Note: If installing another brand of thermostat, follow the
	a) Press the Automation icon from the “Home” screen and then		instructions in the Users Guide for that specific thermostat
		press the Z-Wave Setup icon to display the “Z-Wave Device	to enroll properly into the Z-Wave network.
			Note: Some thermostats do not update temperature
		Management” screen.
	b)		status automatically i.e., Wayne Dalton.
		Press the Z-Wave Enroll/Add icon.	The keypad displays a series of messages:
	2. At the Z-Wave thermostat:		“Please press function key on device”
	a) Select Thermostat; set the Time/Date.		* If not using a Honeywell thermostat, enrollment
	b) Follow the instructions in the thermostat Installation		procedure may vary. Refer to the thermostat instructions
		Guide for “Z-Wave enrollment”.	for enrollment procedure.
	c) To complete inclusion, press Done.
	d)	Press Exit to return to normal operation.	The keypad displays a series of messages:
	3. At the Tuxedo Touch Keypad:		“Please press function key on device”
	a) To verify activation, press the Back icon and wait 30 seconds.		“Adding Controller Unit” “Adding Slave Unit”
		Press the Refresh icon; the new device is displayed.	“Device added successfully”

34